James
Greene Products
Kawasaki Prairie 650
Installation Instructions
For Fender Cover
1.
Remove
the seat as per instruction manual
2.
Release
all Velcroâ
3.
Install
front section (two headlight holes in cover) by inserting cover between grille
area and front bumper. Cover will
install around outside of rack support bars and clip to the edge of fenders.
Position cover around handlebars and Air Cleaner Compartment. Attach Velcro
sections together. Secure all clips and adhesive Velcroâ
4.
Install
rear section, middle part of cover between front of rear rack and rear of
seat area. Cover will go between rack
support bars and clip to the edge of fenders. Secure all clips and adhesive
Velcroâ
5.
When
front and rear covers are installed, position them to cover fenders
completely. Attach supplied adhesive
Velcroâ where needed. (PLEASE NOTE: THE AREA WHERE THE SELF-ADHESIVE VELCROâ IS TO BE PLACED, HAS TO BE CLEAN AND THE VELCROâ SHOULD SIT FOR 24 HOURS TO CURE BEFORE USING).
6.
Reinstall
seat
Your new fender cover is guaranteed by James
Greeneä Products against any defects in material and workmanship for one full
year from the date of purchase. Should
any problems arise, please contact your dealer. No warranty card is necessary.
WARNING:
Prolonged exposure to direct sunlight may result in fading and/or
tendering of the material. Do not store
your ATV with fender cover installed in direct sunlight. Damage resulting from exposure to direct
sunlight cannot be warranted.
n Seat Covers
n Camo Fender Cover Kits
n Front & Rear Lined Rack
Bags
n Hand Warmers
n Cooler Bags
n Accessory Bags
n Partner Packs and Partner
Pack Cushion
n Detachable Rear Cushion
n Elasticized Full ATV Cover
Ask your dealer for information on other James Greeneä Product
Accessories or visit us online at www.jamesgreene.com -All Products Are Made In
The U.S.A.