James
Greene Products
YAMAHAâ GRIZZLYä
Installation
Instructions For Fender Cover
1.
Remove
the seat as per instruction manual
2.
Release
all Velcroâ straps
3.
Remove
the 10mm bolts that attach rear fenders to racks
4.
Install
front section by working cover from front to rear of vehicle. Cover will go around outside of rack support
bars and clip to the edge of fenders.
Secure all clips and Velcroâ straps.
5.
Install
rear section from rear to front under rack, securing all clips and Velcroâ.
6.
When
front and rear covers are installed, position them to cover fenders
completely. Punch small hole in cover
for 10mm fender bolts to be reinstalled.
7.
Reinstall
10mm bolts under rear fenders, check all clips and Velcroâ.
8.
Attach
supplied adhesive Velcroâ where needed. (PLEASE NOTE: THE AREA WHERE THE SELF-ADHESIVE VELCROâ IS TO BE PLACED, HAS TO BE CLEAN AND THE VELCROâ SHOULD SIT FOR 24 HOURS TO CURE BEFORE USING).
9.
Reinstall
seat
Your
new fender cover is guaranteed by James Greeneä Products against any
defects in material and workmanship for one full year from the date of
purchase. Should any problems arise,
please contact your dealer. No warranty
card is necessary.
WARNING: Prolonged exposure to direct sunlight may
result in fading and/or tendering of the material. Do not store your ATV with fender cover installed in direct
sunlight. Damage resulting from
exposure to direct sunlight cannot be warranted. Use only mild soap & water to clean.
Other
Camo Accessories Available
n Seat Covers
n Camo Fender Cover Kits
n Front & Rear Lined Rack
Bags
n Hand Warmers
n Cooler Bags
n Accessory Bags
n Partner Packs and Partner
Pack Cushion
n Detachable Rear Cushion
n Elasticized Full ATV Cover
Ask
your dealer for information on other James Greeneä Product Accessories or
visit us online at www.jamesgreene.com -All Products Are Made In The U.S.A.