James Greene Products

http://www.jamesgreene.com

KAWASAKIâ MULEä CAB ENCLOSURE

Installation Instructions

1. Unzip doors and release all Velcroâ and straps.

2. From rear of Mule, install cover forward over roll cage/frame. Center back section and front windshield, as to be level and straight with cage frame; zip doors.

3. Before supplied Velcroâ can be installed, you must clean areas with alcohol.

4. Install supplied Velcroâ around front, sides and door openings, corresponding to Velcro mate on cover.

5. Attach cover to Velcroâ, securing around headlight.

**Do Not Exceed 25 mph**

**Remove cab completely prior to transporting on highways, where speeds may exceed 25 mph

**Your new Muleä cab’s windows and doors are made of highest quality clear plastic. It will however scratch, if not handled correctly

**Use mild soap and water only to clean all surfaces

Your new cover is guaranteed against any defects in material and workmanship for one full year from the date of purchase. Should any problems arise, please contact your dealer. No warranty card is necessary.

WARNING: Prolonged exposure to direct sunlight may result in fading and/or tendering of the material. Do not store your ATV with fender cover installed in direct sunlight. Damage resulting from exposure to direct sunlight cannot be warranted.