James
Greene Products
HONDAâ RUBICON
Installation Instructions
For Fender Cover
1.
Remove
the seat as per instruction manual
2.
Release
all Velcroâ straps
3.
Install
front section by working cover from front to rear of vehicle. Cover will go around outside of rack support
bars and clip to the edge of fenders. Secure all clips and Velcroâ straps. Attach clips with elastic straps to rear of fuel
tank cover.
4.
Install
rear section from rear to front under rack, securing all clips and Velcroâ, and attaching to Velcroâ on front cover.
5.
When
front and rear covers are installed, position them to cover fenders
completely. Attach supplied adhesive
Velcroâ where needed. (PLEASE NOTE: THE AREA WHERE THE SELF-ADHESIVE VELCROâ IS TO BE PLACED, HAS TO BE CLEAN AND THE VELCROâ SHOULD SIT FOR 24 HOURS TO CURE BEFORE USING).
6.
Reinstall
seat
Your new fender cover is guaranteed by James
Greeneä Products against any defects in material and workmanship for one full
year from the date of purchase. Should
any problems arise, please contact your dealer. No warranty card is necessary.
WARNING:
Prolonged exposure to direct sunlight may result in fading and/or
tendering of the material. Do not store
your ATV with fender cover installed in direct sunlight. Damage resulting from exposure to direct
sunlight cannot be warranted.
Other
Camo Accessories Available
n Seat Covers
n Camo Fender Cover Kits
n Front & Rear Lined Rack
Bags
n Hand Warmers
n Cooler Bags
n Accessory Bags
n Partner Packs and Partner
Pack Cushion
n Detachable Rear Cushion
n Elasticized Full ATV Cover
Ask your dealer for information on other
James Greeneä Product Accessories or
visit us online at www.jamesgreene.com -All Products Are Made In The U.S.A.