James Greene Products

www.jamesgreene.com

HONDAâ RINCONÔ

Installation Instructions For Fender Cover

1. Remove the seat as per instruction manual

2. Release all Velcroâ straps

3. Install front section by working cover from front to rear of vehicle. Cover will go between outside rack support and inside rack support bars on each side of machine and clip to the edge of fenders. Secure all clips and Velcroâ around rack supports. (Be sure to install adhesive VelcroÒ to corresponding sections behind headlights)

4. Install rear section (one left and one right) by inserting cover between inner rack support and outer rack support securing all clips and Velcroâ.

5. Attach rear cover sections to Velcroâ on front cover at bottom of gas tank.

6. When front and rear covers are installed, position them to cover fenders completely. Attach supplied adhesive Velcroâ where needed. (PLEASE NOTE: THE AREA WHERE THE SELF-ADHESIVE VELCROâ IS TO BE PLACED, HAS TO BE CLEAN AND THE VELCROâ SHOULD SIT FOR 24 HOURS TO CURE BEFORE USING).

7. Reinstall seat

Your new fender cover is guaranteed by James Greeneä Products against any defects in material and workmanship for one full year from the date of purchase. Should any problems arise, please contact your dealer. No warranty card is necessary.

WARNING: Prolonged exposure to direct sunlight may result in fading and/or tendering of the material. Do not store your ATV with fender cover installed in direct sunlight. Damage resulting from exposure to direct sunlight cannot be warranted.

Other Camo Accessories Available

n Seat Covers

n Camo Fender Cover Kits

n Front & Rear Lined Rack Bags

n Hand Warmers

n Cooler Bags

n Accessory Bags

n Partner Packs and Partner Pack Cushion

n Detachable Rear Cushion

n Elasticized Full ATV Cover

Ask your dealer for information on other James Greeneä Product Accessories or visit us online at www.jamesgreene.com -All Products Are Made In The U.S.A.